KEP 228mm PORSCHE PRESSURE PLATES (9")
Fits all 914 and
pre 1970 911 transaxles using the KEP 9" flywheel and special KEP Porsche
release bearing. Torque capacities using a stock disc are shown below.
9" STOCK
|
|
200 ft. lb.
|
|
Stock 228mm VW Bus pressure plate. Suitable for engines under 3 liter for
street use and less than 200 ft. lb. of torque.
|
9" STAGE I
|
|
223 ft. lb.
|
|
This pressure plate works well with small Porsche 911 powered 914's or
small V6 camper vans. Enjoy good holding power and easy pedal effort.
|
9" STAGE II
|
|
273 ft. lb.
|
|
This is one used for larger V6 and stock V8 offroad applications and is
used by winning unlimited class offroad racers. Also very popular for use in
V8 powered 914's under 350 HP.
|
9" STAGE III
|
|
378 ft. lb.
|
|
This pressure plate is designed to handle 500 HP on an organic disc. Good
for street or race applications with lots of power.
|
9” STAGE IV
|
|
420 ft. lb.
|
|
Available at special request.
|
KEP 215mm PORSCHE PRESSURE PLATES
Porsche 215mm pressure plate for 914's
and '65-69 Porsche 911 features stronger diaphragm and a full circle torque link
system to prevent failure due to excessive torque. We also offer this pressure plate with
an aluminum face for a lighter weight application.
Stock - (for comparison). Holds 180 ft. lbs. of torque.
Stage I - 215mm Pressure Plate. Holds 230 ft. lbs. of torque.
Stage II - 215mm pressure Plate. Holds 270 ft. lbs. of torque.
KEP 225mm PORSCHE 915 TRANSAXLE PRESSURE PLATES
Porsche 225mm 911 clutch package. Primarily sold as a clutch kit to
Kit Car builders complete with installed bearing, ring gear, fasteners and all
new genuine German parts. Fits '72 or newer 915 Porsche transaxle. The 360 ft.
lb. of torque capacity handles most stock 350 Chevrolet V8 engines.
KEP Porsche 915 HD pressure plate. Holds 477 ft. lbs. of torque with a
stock disc. We also offer this in all aluminum for a lighter weight
application.
KEP PORSCHE 930, 944 Turbo & G50 HD PRESSURE
PLATES
KEP Porsche 930, 944 and '87-89 G50
racing pressure plates are made with an aluminum cover for lighter weight,
ductile face for durability and higher clamp load for an increased torque
capacity of over 600 ft. lbs. of torque using a stock disc. These are not
modified factory parts. They are CNC machined then accurately assembled,
balanced, and tested. We offer
three load ratings from 500 to 700 ft. lb. of torque.
Torque Capacity with stock disc
Clutch
|
Stock
|
KEP
|
Increase
|
KEP 930 - '75-77
|
374
|
600
|
60%
|
KEP 930 - '78-88
|
423
|
600
|
42%
|
KEP G50 - '87-89
|
460
|
600
|
30%
|
KEP 944 turbo
|
378
|
600
|
59%
|
HOME